Hi,
I have a similar problem with Redhat 5.2 only the displacement and
partial repeat of the screen occurs in the vertical direction. I have a
black band at the lower 1/8 of screen. Below this a small portion of the
of a second copy of the screen appears. It looks like vertical sync
problems on a TV screen but it's stationary rather than rolling. I'm
running this on a Gateway 2100 and had to select LCD screen as only option
for video card. My card is:
SOLO2100: Video Controller= Cirrus 7548 with DCI/Direct draw
compatability,
motion video acceleration, continuous X/Y upscaling to 1024 x 768, and
an enhanced Bit-BLT engine. Video Subsystem Interface: 32-bit PCI bus
memory interface.
Monitor frequencies: horiz 38.6, vert 60 Hz
When I try to change the video scanning specs and/or resolution the
installation program keeps changing it back to the ~600 x ~800 values.
What should I try? Thanks for suggestions.
Lou Mulieri
Hinesburg, VT
On Sat, 19 Jun 1999, Herman wrote:
> At 12:09 PM 6/19/99 +0000, [EMAIL PROTECTED] wrote:
> > I have installed redhat 5.0. when I am working in x windows
> > one part of my x-window (for example the right portion) is out
> > of the screen and is coming on the left hand side.The pointer
> > is not pointing to the right position for example If I bring
> > the pointer to any position and click it does'nt proceed
> > further for that I have to bring the pointer slightly to
> > the right of the particular position
>
> I had the same problem. I had to select a different monitor
> to solve the problem. My video-card was detected OK.
>
> Herman Aa.
>
>
>
