Sorry for the misconception in the subject line. I just recompiled with
the JE UHCI driver and tested it and got the following results when it
stopped about 37Meg into the transfer:
.........
pegasus.c: failed tx_urb -6
pegasus.c: failed tx_urb -6
pegasus.c: failed tx_urb -6
..... repeating .....
Difference being that the ethernet would not respond after this occured
and had to ifconfig eth0 down ; ifconfig eth0 up to bring it back.
I appreciate your help and will see what I can find in the pegasus code.
-Jason
On Sat, 20 May 2000, Johannes Erdfelt wrote:
> On Sat, May 20, 2000, Jason Sharpee <[EMAIL PROTECTED]> wrote:
> > I was stress testing my Linksys 10/100TX usb ethernet adapter with the
> > 2.3.99pre9-2 usb-uhci and pegasus drivers, by ftp'ing a 750Meg file.
> > Always at about ~500megs into the transfer I get the following printk
> > messages.
> >
> > ........
> > pegasus.c: eth0: Tx timed out. Reseting...
> > usb-uhci.c: ENXIO c0010200, flags 0 urb c10c60b8, burb c10c60b8
> > pegasus.c: failed tx_urb -6
> > usb-uhci.c: ENXIO c0010200, flags 0 urb c10c60b8, burb c10c60b8
> > pegasus.c: failed tx_urb -6
> > .....last 2 messages repeat until FTP times out at 900 secs....
> >
> > This is an IOpener system with VIA chipset. Usb detects the irq at 15.
> >
> > I would like to track this down but am unsure of whether pegasus or uhci
> > is the problem here. Let me know if there is anything else I can provide
> > or look at to help.
>
> First off, contrary to the subject, this is about usb-uhci.c, not
> uhci.c.
>
> That error message is generated when an URB is trying to be submitted
> for a pipe that already has an active URB.
>
> However, looking at that error message, it looks like it's trying to
> resubmit an already active URB.
>
> I'd take a look at the pegasus driver first.
>
> JE
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
