On 28 Jul 2003 22:50:24 -0600 Ralph Sanford <[EMAIL PROTECTED]> wrote:
> On Mon, 2003-07-28 at 22:02, Net Llama! wrote: > > On 07/28/03 19:53, Rick Sivernell wrote: > > > > > On Mon, 28 Jul 2003 21:59:40 -0400 > > > dep <[EMAIL PROTECTED]> wrote: > > > > > > > > >>quoth Rick Sivernell: > > >>| Suse users needed<g> > > >>| > > >>| Got myself a copy of suse 8.0 pro. most evertything is working ok, > > >>| but not ifconfig. This was a full fresh install over Caldera 3.1.1. > > >>| Now cardctl status ident and config is proper as it should be. pcmcia > > >>| start says it is ok but when I do ifconfig all I get is lo setup and > > >>| running. it seems to be about one step away from complete. I set > > >>| everythoing per Yast2, but that failed to set > > >>| /etc/pcmcia/network.opts at all. I fixed that, Not sure what to do > > >>| next here. > > >>| > > > DEP > > > > > > Suse Installed lilo, I did find a acpi=y set it to off and rebooted. no > > > joy. > > > I have found that the system is using axnet_ca it should be pcnet_cs. Can > > > not find where to change it at. Found it on the last line of dmesg. boot > > > fine and acts as if pcmcia is ready, dongle has all lights bright, cardctl > > > says it is good and it finds the proper card Linksys pcmpc 100. just no > > > ifconfig for pcmcia. > > > > > > I think the pcmcia modules are defined somewhere like > > /etc/pcmcia/pcmcia.opts. grep through /etc/pcmcia, assuming that SuSE puts > > their pcmcia stuff in there. > > > Try /etc/pcmcia/config or /etc/pcmcia/wlan-ng.conf > Find your card and see what SuSE has bound it to. If SuSE shows it as > bind "axnet_cs" then change it to read bind "pcnet_cs" > > Hope this helps. > > -- > Ralph Sanford - If your government does not trust you, > [EMAIL PROTECTED] - should you trust your government? > > DH/DSS Key - 0x7A1BEA01 > > _______________________________________________ > Linux-users mailing list > [EMAIL PROTECTED] > Unsubscribe/Suspend/Etc -> > http://www.linux-sxs.org/mailman/listinfo/linux-users Ralph I have not found where the axnet_cs is loaded. I have tried all suggestions and do appreciate the help. I am stepping back and see what I can do next. -- Rick Sivernell Dallas, Texas 75287 972 306-2296 [EMAIL PROTECTED] Gentoo Linux Registered Linux User .~. / v \ /( _ )\ ^ ^ In Linux we trust! _______________________________________________ Linux-users mailing list [EMAIL PROTECTED] Unsubscribe/Suspend/Etc -> http://www.linux-sxs.org/mailman/listinfo/linux-users