A documented erratum of the RF212 chip describes that some versions of
RF212 may not be properly reset by the standard reset procedure. The
described workaround seems to not fully work either; my RF212 chips will
not correctly receive any frames unless they are taken from RX mode to
TRX_OFF and back to RX mode, effectively forcing a up-down-up-cycle.
Going to TRX_OFF and to RX without intermediate state changes at least
once fixes this.
The same transition is allowed for RF230, so simply do it all the time.
Signed-off-by: Phoebe Buckheister <phoebe.buckheis...@itwm.fraunhofer.de>
---
drivers/net/ieee802154/at86rf230.c | 25 +++----------------------
1 file changed, 3 insertions(+), 22 deletions(-)
diff --git a/drivers/net/ieee802154/at86rf230.c
b/drivers/net/ieee802154/at86rf230.c
index 9e3bb34..77b8111 100644
--- a/drivers/net/ieee802154/at86rf230.c
+++ b/drivers/net/ieee802154/at86rf230.c
@@ -930,18 +930,9 @@ static int at86rf230_hw_init(struct at86rf230_local *lp)
if (rc)
return rc;
- dev_info(&lp->spi->dev, "Status: %02x\n", status);
- if (status == STATE_P_ON) {
- rc = at86rf230_write_subreg(lp, SR_TRX_CMD,
- STATE_FORCE_TRX_OFF);
- if (rc)
- return rc;
- msleep(1);
- rc = at86rf230_read_subreg(lp, SR_TRX_STATUS, &status);
- if (rc)
- return rc;
- dev_info(&lp->spi->dev, "Status: %02x\n", status);
- }
+ rc = at86rf230_write_subreg(lp, SR_TRX_CMD, STATE_FORCE_TRX_OFF);
+ if (rc)
+ return rc;
/* configure irq polarity, defaults to high active */
if (pdata->irq_type & (IRQF_TRIGGER_FALLING | IRQF_TRIGGER_LOW))
@@ -969,16 +960,6 @@ static int at86rf230_hw_init(struct at86rf230_local *lp)
/* Wait the next SLEEP cycle */
msleep(100);
- rc = at86rf230_write_subreg(lp, SR_TRX_CMD, STATE_TX_ON);
- if (rc)
- return rc;
- msleep(1);
-
- rc = at86rf230_read_subreg(lp, SR_TRX_STATUS, &status);
- if (rc)
- return rc;
- dev_info(&lp->spi->dev, "Status: %02x\n", status);
-
rc = at86rf230_read_subreg(lp, SR_DVDD_OK, &status);
if (rc)
return rc;
--
1.7.9.5
------------------------------------------------------------------------------
Android apps run on BlackBerry 10
Introducing the new BlackBerry 10.2.1 Runtime for Android apps.
Now with support for Jelly Bean, Bluetooth, Mapview and more.
Get your Android app in front of a whole new audience. Start now.
http://pubads.g.doubleclick.net/gampad/clk?id=124407151&iu=/4140/ostg.clktrk
_______________________________________________
Linux-zigbee-devel mailing list
Linux-zigbee-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linux-zigbee-devel
