On Aug 11, 2009, at 9:43 PM, Kumar Gala wrote:
On Aug 11, 2009, at 5:27 PM, B.J. Buchalter wrote:
So it seems like the XIO2000(A) is being misconfigured or
misidentified, and rather than finding the configured bus behind
the bridge, it is doing "something else", and as a result, not
finding the PCI OHCI FireWire controller on the PCI side of the
bridge.
Unfortunately I have no real idea where to start looking at this...
Any ideas? Or is there a better place to be posting about this?
This is a reasonable place to post this. Can you see what u-boot
reports for its PCI/e bus scan?
Thanks,
This is what u-boot says:
U-Boot 1.3.3 (Jun 19 2008 - 10:47:48) MPC83XX
Reset Status: Software Hard, External/Internal Soft, External/Internal
Hard
CPU: e300c4, MPC8377E, Rev: 1.0 at 666.666 MHz, CSB: 333.333 MHz
Board: Freescale MPC837xERDB
I2C: ready
DRAM: 256 MB
PCIE0: Link
PCIE1: No link
FLASH: 8 MB
NAND: 32 MiB
In: serial
Out: serial
Err: serial
Net: TSEC0, TSEC1
eSDHC: No SD/MMC card found
SATA: SATA0 (No RDY)
SATA1 (No RDY)
Hit any key to stop autoboot: 0
=> set serverip 10.0.1.40
=> run tftpnfsboot
If there is additional information to be found, I'd be happy to
collect it.
Best regards,
B.J. Buchalter
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
