> -----Original Message----- > From: Linuxppc-dev [mailto:linuxppc-dev-bounces+tie- > fei.zang=freescale....@lists.ozlabs.org] On Behalf Of Benjamin > Herrenschmidt > Sent: Friday, June 07, 2013 12:40 PM > To: Timur Tabi > Cc: Xie Shaohui-B21989; Liu Qiang-B32616; Zang Roy-R61911; tiejun.chen; > Fleming Andy-AFLEMING; Bhushan Bharat-R65777; linuxppc- > d...@lists.ozlabs.org > Subject: Re: SATA FSL and upstreaming > > On Fri, 2013-06-07 at 13:52 +1000, Benjamin Herrenschmidt wrote: > > > So I got the rev2 chip today, put it in, and PCI-E is still not > > getting a link. Since the LEDs of the e1000 aren't coming up at all, I > > *suspect* the slots are getting no power. > > > > Is there a power control somewhere ? Maybe some DIP or jumpers that > > might have gone off ? > > Forget it, reset all the jumpers to the default setup (found the doc !) > and they come up now in slot 4 and 7. It also looks like uBoot now has an > e1000 driver so I don't have to use fman (for which I believe there is > still no upstream driver right ?) fman in u-boot has been up streamed. It should work. > > BTW. Is that normal during boot ? > > Net: Initializing Fman > Fman1: Uploading microcode version 106.1.7 PHY reset timed out PHY reset > timed out PHY reset timed out PHY reset timed out You can ignore the timeout. Do you plug other card (for example SGMII card) on the board? u-boot detects some card in the slot and tries to init the PHY but fails. Roy
_______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev