Is there a converter from Sweave to LaTeX? Check it in the menu Tools-->Preferences-->Converters. Normally you should have at least four converters from Sweave to different types of LaTeX output.
Regards, Yihui -- Yihui Xie <xieyi...@gmail.com> Phone: 515-294-2465 Web: http://yihui.name Department of Statistics, Iowa State University 2215 Snedecor Hall, Ames, IA On Wed, Jul 13, 2011 at 12:25 PM, Z.L. Li <terp.u...@gmail.com> wrote: > Dear list members, > As a newbee to Lyx, recently I tried to set it up and use the Sweave module > to document some R codes > I have. I ran into problems very similar to the one discussed earlier in > this tread: > http://www.mail-archive.com/lyx-users@lists.lyx.org/msg87193.html > I looked through the replies, tried and same problem remained. I have listed > what I did below and hope > to find a cure. > I tried the following steps in two systems: XP + MikTex 2.9 + R 2.13.0 / > Win7 + MikTex 2.9 + R 2.13.0 > 1. put "C:\Program Files\MiKTEX 2.9\miktex\bin" and "C:\Program > Files\R\R-2.13.0\bin" > into the PATH system variable. > 2. download and install RTool for 2.13.x or later, checked to add the > appropriate Rtools path during > installation. And "C:\Program Files\Rtools\MinGW\bin", "C:\Program > Files\Rtools\MinGW64\bin" > are in the PATH variable, too. > 3. copy noweb.sty and Sweave.sty to "C:\Program Files\MiKTeX > 2.9\tex\latex\misc" and Refresh FNDB > using the MikTex setting interface. I can use "kpsewhich" under command > mode to locate these two > style files. > 4. download LyX-2.0.0-3-Installer and install Lyx. After installation, run > the Reconfigure once. > When these steps finished, I opened the test file sweave.lyx, the "View" > button is "disabled". I can see > the Sweave module is loaded in Lyx from the Preference tab with the typical > warning: > "WARNING: Some required packages are unavailable!" > I am pretty much stuck at this point and don't know what else I can do. Any > help is truly appreciated. > Regards, > Ziliang > > -- > Life goes on.... >
