Hello there! I had my first crash on a Rex# that I can't get myself out of, curious if anybody has any tips.
I was in the process of creating a clean bank for a new project, and it failed somewhere near the end. I RESET and then ran `CALL 63012` to reload REX, but now whenever I start REXMGR, it attempts to load/write something and hangs. I've done a cold reset, pulled batteries etc, so I think it's in eeprom/flash somewhere. Here's a shot of what I'm seeing: [image: Screen Shot 2023-05-25 at 9.13.23 PM.jpg] If images don't work here, launching REXMGR shows the standard top line with "REX #2.1" in the top left, and the bottom right is the progress bar, which fills up most of the way and then hangs. Any way I might peek/poke my way back to a usable state? I don't care about the in progress job that failed, so if I could clear a flag or get it to just abandon it that would be fine. Thanks as always! -Charlie