When I boot the disk that has the original boot loader. I get the following:

 UART clock 100000 KHz

CLOCK: MMC clock 50000 KHz

CLOCK: QSPI clock 3125 KHz

RESET: COLD

SDRAM: Initializing MMR registers
SDRAM: Calibrating PHY

SEQ.C: Preparing to start memory calibration



U-Boot SPL 2013.01.01 (Nov 30 2016 - 14:20:53)

BOARD : Altera SOCFPGA Cyclone V Board

CLOCK: EOSC1 clock 25000 KHz

CLOCK: EOSC2 clock 25000 KHz

CLOCK: F2S_SDR_REF clock 0 KHz

CLOCK: F2S_PER_REF clock 0 KHz

CLOCK: MPU clock 800 MHz

CLOCK: DDR clock 400 MHz

CLOCK:?O?WR⑪?

------------------------------------
It stopped with some of unicode characters or control characters. I assume 
that when I stop seeing output on the serial console that I am at boot 
prompt because that is about the amount of time it normally takes to reach 
the u-boot window to choose normal kernel or safe mode. 

By the way when I type characters I just see the RX LED. When the DE10 
starts from either uSD I just see the TX led while it is processing the 
initial messages. On the one I am trying to build, when it goes crazy, I 
see both the RX and TX either flashing at the same time or alternating (at 
115200 it is really too fast to tell for sure).

-- 
website: http://www.machinekit.io blog: http://blog.machinekit.io github: 
https://github.com/machinekit
--- 
You received this message because you are subscribed to the Google Groups 
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to machinekit+unsubscr...@googlegroups.com.
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.

Reply via email to