David Reid wrote:
> I have amajor lines editing project going and the trips back n forth
> to change Node editing modes is getting hectic.
>
Hi David!
I agree, I had the same experience recently.
I found that there is a mapper relative setting for this, i. e.
set map move nodes 0
set map move nodes 1
where the value 0 stops moving duplicate nodes and the value 1 turns it
on.
Type these two lines into your Mapbasic window and activate the one
needed.
But I am using MI Pro v5.5 here, maybe this does not work in your
version?
For the same reason, I cannot provide you with a button pad since I have
no v4 MB compilator.
Maybe you should consider an upgrade? Much has happened in the last
versions.
Regards, Mats.E
--
:::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
:Email/ [EMAIL PROTECTED] ICQ#9517386 :
:---------------------------------------------------------------------:
:Mail/ GISKRAFT, Mats Elfstroem, Vaepplingv 21, SE-227 38 LUND, SWEDEN:
:Phones: +46 46 145959, +46 70 595 3935 :
:::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]