> > Add support for InvenSense mpu3050/6000 Gyroscope chip
> >
> > The driver is used to support gyroscope device, and it provides an
> > interface to control accelerometer and e-compass (optional).
> >
> > The driver also provides sysfs and input event for Meego's sensor
> > framework.
> >
> > Based on linux-kernel-2.6.35 doesn't have support for gyroscope
device,
> > would Meego accept this patch into mid-ref tree?
> >
> > Thank you.
> >
> > The patch list shows as follows:
> > [RFC/PATCH 1/9] mpu3050/6000: Makefile, Kconfig and README
> > [RFC/PATCH 2/9] mpu3050/6000: header files [1/2]
> > [RFC/PATCH 3/9] mpu3050/6000: header files [2/2]
> > [RFC/PATCH 4/9] mpu3050/6000: the config of motion library in driver
> > layer
> > [RFC/PATCH 5/9] mpu3050/6000: i2c and sensorfw interfaces
> > [RFC/PATCH 6/9] mpu3050/6000: mpu char device interface
> > [RFC/PATCH 7/9] mpu3050/6000: compass support
> > [RFC/PATCH 8/9] mpu3050/6000: accelerometer support for Bosch chip
[1/2]
> > [RFC/PATCH 9/9] mpu3050/6000: accelerometer support [2/2]
> >
> > The path to enable this driver:
> > -> Device Drivers
> > -> Misc devices
> > -> Motion Sensors Support
> >
> > Signed-off-by: Joseph, Lai <[email protected]>
>
> Would anyone kindly give me some comments about this driver?
> I will very appreciate that.
Dear Arjan:
Does the architecture or format of this driver have any problem?
Would you please provide some comments?
Thank you.
_______________________________________________
MeeGo-kernel mailing list
[email protected]
http://lists.meego.com/listinfo/meego-kernel
