RE: wheels

[Terry Rudd]

Daniel,   PCD on a 1600 is 4 x 4.5 (114.3mm) and standard backspace is 3 15/16" or ~100mm; the offset on a Nissan (240K/Zed) 6" rim is 12mm but a 1600 will take a wheel with a backspace of  85 - 115mm depending on which hubs are being used. This is around 0 to +25mm in terms of offset depending on how wide the rims are. Some wheels that are in the range are Sigma, TRX (may not fit with 1600 hubs, OK with 240K/200B), Triumph and some Toyota (watch these as Toy uses 2 bolt patterns).   There are very few new wheels that are available in 16 x 7 to fit. Performance S1670's are one and you can usually specify the offset you require but they are a very tight fit and unfortunately they don't make a 15x6 (only 14x6 or 15x7).   regards, Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Daniel Kroehn Sent: Tuesday, 25 December 2001 6:01 PM To: [EMAIL PROTECTED] Subject: wheels List,   I know this is a question that goes around from time to time but its one thin that confuses me.  I'm looking at getting a set of new wheels for the ol' 1600 as I'm getting a bit tired of the 13's I have on it at the moment.  What stud spacing and offset should I be looking out for that suit my car?  I'm looking at getting some 16 x 7's if I can find some that suit.  My guards have already been rolled a little and have the lips already turned up.  Is there any AFTERMARKET wheels that fit other cars that will bolt straight onto my datto.  ie.  Would a set of aftermarket wheels made for a TRX bluebird suit the 1600?   Any help will be appreciated.   Merry Christmas   Daniel Kroehn --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------