grease shows up in time I use one tube per side and 3/4 of it
Weigh it, there's a spec.
Now is the magic part, need to seat the bearing, so spin the hub/rotor and tighten to hand tight and just a bit more.
I've always used the old bearing race and a hammer to drive the new race in. Carefully.
when this was done last). IIRC I can just open the taps one at a time and let gravity pull fluid to flush.
In your dreams. Pump, or use a MityVac to suck it through, or use a pressure bleeder.
start farthest from the MC and move back, so right rear, left rear...
Yep.
the hood on this car is nasty). That seems like a good idea unless theres a dried out seal or oring under there...
You can get new reservoir seals. Not very expensive. -- Jim _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
