It's page 148 in the electric diagrams part of the cd.
Wilton
----- Original Message -----
From: "Dieselhead" <126die...@gmail.com>
To: "Mercedes Discussion List" <mercedes@okiebenz.com>
Sent: Sunday, October 09, 2011 10:25 PM
Subject: Re: [MBZ] 124 seat
Thanks, Where did you find the diagram? Is it in the cd and I just
could not find it?
The pdf you sent is the circuits before the switch. I needed the
wiring at the seat itself, and inside the seat. But for now, I
figured out enough to get by.
'Just sent the seat electric diagram to you - page 148 of the pdf.
Wilton
----- Original Message ----- From: "Dieselhead" <126die...@gmail.com>
To: <mercedes@okiebenz.com>
Sent: Sunday, October 09, 2011 1:53 PM
Subject: [MBZ] 124 seat
The CD at www.w124performance.com only has wiring diagrams INDEX
for 1993 on. No diagrams for the seats.
************************
Well, the USA models all have electric seats, and they are
different than the sketch in the CD section 91. There is a motor
right and left. What I would need to do is run the right motor
forward to even up the seat back. There is NO ROD connecting right
and left.
Without diving into the wiring diagrams, which are likely
incomplete on the CD, it may be easier at this point to swap the
seat backs. It would be for sure easier if the donor seat was the
right color.
i will spend a small amount of time looking at the wiring to see if
the right motor could be run a bit
************************
The driver's seat in my 87 300D has had a twisted back since I got
the car. Today's project is the seat.
Q1: Are the passenger and driver's seat (above the mounting and
slides) interchangeable as are the 123?
I have a spare passenger seat that I can use for parts, but i'd
have to change the seat covers.
Q2: Someone in the past suggested there is a rod in the back tilt
mechanism that might be off one tooth left to right that causes the
back frame to twist. However on the 124 seat, I have not found
this rod or how to change it. I am not seeing much helpful on the
section 91 of the CD.
One possibility is to remove the backs, of both seats and swap the
covers. That is a lot of work, and if there is an easier way, I am
listening.
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
