Since I installed new spheres it rides less harshly. I don't notice excessive bounciness, but it fails the bounce test at rest (won't recover quickly enough after pressure is applied to the rear bumper).
David: Are you saying that all components are sound, and that applying 32-501 will solve my problem? On Sat, Apr 19, 2014 at 4:50 PM, Mitch Haley <m...@voyager.net> wrote: > David Bruckmann wrote: > >> Sounds like they further misadjusted the linkage. The valve is working if >> they were able to influence the resting height. The system's operation is >> clearly described in 32-501. >> It should be adjusted so that the unloaded vehicle's resting height is >> determined only by the base pressure. The height control valve should only >> activate if the rear end is deflected significantly (a couple of inches). >> But if they've overadjusted the lever, it may not be activating when load >> is added to the car. When moving the height control lever (disconnected >> from the torsion bar linkage), you can feel the point at which the base >> pressure circuit takes over from the height control circuit. There's a very >> subtle notch feeling as the height control lever strikes the filling ball >> valve. >> Remember there are two separate control modes: the base pressure circuit >> (when functioning correctly) completely overrides the height control lever >> in the downwards direction after a certain point. You can put the lever all >> the way to the drain position and the car will not fall below normal >> resting height. The base pressure circuit actually moves the ball valve out >> of range for the control lever to prevent loss of base pressure. >> We are talking about adjustments of a few millimetres here. This is not >> something that should be done by people who haven't read 32-501. >> D. >> > > Could the problem be that it was too high with (wrong) springs and base > pressure, so they adjusted it to "drain" and it lowered but then wouldn't > pump up? > > Andrew, has this car been bouncing like a pogo stick since you got it, or > is that a recent development? > Mitch. > > > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > All posts are the result of individual contributors and as such, those > individuals are responsible for the content of the post. The list owner > has no control over the content of the messages of each contributor. > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com All posts are the result of individual contributors and as such, those individuals are responsible for the content of the post. The list owner has no control over the content of the messages of each contributor.
