OK, so if I read this correctly, I am supposed to pull the injectors rather than the glowplugs?
Randy B -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of John Berryman Sent: Monday, February 13, 2006 5:03 PM To: Mercedes Discussion List Subject: Re: [MBZ] A New Toy On Monday, February 13, 2006, at 08:40 PM, R A Bennell wrote: > My car is a 76 300D so a 115.XXX model and a 617.XXX engine. The > adapter > screws into the hole where the glowplug would normally be, right? This > one > says it is M24X2.0 which I assume is 24 mm. > The injector thread is M24. Filament type series GPs are M18ish, pencil type parallel GPs M12. If you intend to check compression at the GPs an elbow(90) will be needed. I pull all the injectors when checking compression, easier access. Johnny B. I Mac Therefore I am _______________________________________ http://www.striplin.net For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://striplin.net/mailman/listinfo/mercedes_striplin.net