How about using some of that aluminum solder
rod that the AC people use to solder the
aluminum lines in AC units. You could solder
the perch right back onto the case. You may
even be able to build it up a bit to make it
hold better. Should be stronger then JB weld.
I used some to fix a hole in the condenser
joint on the 123 last year and it has worked
great so far. Got it at a welding supply
store. It was only about $28 for 5 sticks. If
I remember right they have different
formulations for strength. Just takes a
propane torch to do the job.
Jim Cathey via Mercedes wrote:
I think if you were so inclined you could absolutely fabricate some kind of
JB-Weld attached perch for your coil.
Might take a bit of doing, but could it be all that worse than my welding the
crankcase back together on my
tiller when it threw a rod through the side?
-- Jim
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
