Same problem when I did mine, even assembled it correctly (or the same
way it came apart anyway) and it still leaked a bit. Drained it, put
some gasket sealer on the washers and reassembled and that has held tight.
Oh impure mechanical not-approved-by-Benz hacking, you offend Wotan et
al. but it works, so there.
--R
[EMAIL PROTECTED] wrote:
Kevin feel you pan. I think I ended up using a slight coat of lock tight to
solve the problem on that fill tube on my 1977. Cannot just torque the *&^%
out of it to stop it as I recall/Tom
----- Original Message -----
From: "kevin kraly" <[EMAIL PROTECTED]>
To: "Mercedes Discussion List" <mercedes@okiebenz.com>
Sent: Thursday, November 02, 2006 6:04 PM
Subject: Re: [MBZ] Oil Sucker for Tranny Juice
I might as well pull the bango fill tube. Problem was last
time I did this on my 1977 300D I did not seal the filler tube right and
it
leaked real bad and I had to go back and correct. Operator error
