On Fri, 20 Jun 2008 23:02:38 -0400 Peter T. Arnold <[EMAIL PROTECTED]> wrote:
> I'm not a wizard at this, maybe some help out there? > > I bought a new Hitachi 250GB hard drive from Tiger. It came with no > instructions at all. > I want to use it as a slave. > I installed it, WinXP found it on the first boot, or so the little > pop-up said. > > Now it's no where in my system, I can't find it ?? > > I can find it in "Control Panel/devices" Looks good there. > > I'm sure I have jumpers wrong, I can find no info. > > > Suggestions? Search on Hitachi's website for the manual on the disk. That will tell you where the jumpers need to be. Shut down the computer and boot into your BIOS screen. Look for two disks listed, one of which may be the Hitachi. If both disks show up, your jumpers are correct. Before XP will allow you to use it, you need to format it and then tell the system where to mount it. I've done it in the past, but I don't recall the steps. As I recall, the information about the steps was hard to locate. Craig _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com