Thx Craig - Can't find where I saw the Hard V Soft o-rings (must of dreamed it) - I need the donuts for the '91 300D that go at the very end of the rear mufler - you;re right - no choice. Maybe you can help with the location of the other muffler hanger shown - perhaps that's the figure 8 you mentioned?
It's p/n H8050-26058 - I;ll order one - but need to figure out where it goes ;-) I also need the donuts for the 240D but it's clear where they go - Thx for the help -- Larry T (66 MGB, 74 911, 91 300D) www.youroil.net for Oil Analysis and Weber Parts Test Results http://members.rennlist.com/oil PORSCHE POSTERS! youroil.net 800-583-8601 Weber Carb Info http://members.rennlist.com/webercarbs ----- Original Message ----- From: "Craig McCluskey" <[EMAIL PROTECTED]> To: "Mercedes Discussion List" <mercedes@okiebenz.com> Sent: Sunday, June 22, 2008 10:56 PM Subject: Re: [MBZ] Muffler O-Rings > On Sun, 22 Jun 2008 20:24:00 -0400 "LarryT" <[EMAIL PROTECTED]> wrote: > >> Hi all - >> I was going to order some new muffler o-rings from Rusty for my 78 >> 240D >> and 91 300D but one of the says I have a choice of Hard or Soft O-Rings. > > You're going to have to be a little more specific, Larry. According to > Rusty's website, there are no muffler o-rings. > > For the '78 240D, there is a muffler hanger (commonly called donut), > pictured at http://img.eautopartscatalog.com/live/H805025717.JPG > (unfortunately, a poor picture) that's used to suspend the rear part of > the exhaust system. > > I don't see a choice between hard and soft. > > > For the '91 300D/2.5, there is an exhaust hanger at > http://img.eautopartscatalog.com/live/H805026058AFT.JPG and an Exhaust > Hanger Soft Compound Small round at > http://img.eautopartscatalog.com/live/H805014328.JPG > > These two do not look at all like each other. > > > In the past, I've seen a choice between plain round ones like > > http://img.eautopartscatalog.com/live/H805014328.JPG > > and ones shaped more like a figure-8 like > > http://img.eautopartscatalog.com/live/H805025717.JPG > > for W123s. The plain round ones are easier to install and the figure-8 > ones keep the muffler from bouncing around as much. > > > Craig > > _______________________________________ > http://www.okiebenz.com > For new parts see official list sponsor: http://www.buymbparts.com/ > For used parts email [EMAIL PROTECTED] > > To Unsubscribe or change delivery options go to: > http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com