No prob pete! oh, one other thing, if the button doesn't pop out right away, be sure to leave the room before the monitor blows to bits.
At 12:51 PM 5/5/2000 -0400, Pete Ruehle wrote: >Thanks Ernie!!! I'll give it a try! > >> -----Original Message----- >> From: Ernie Gemmel [SMTP:[EMAIL PROTECTED]] >> Sent: Friday, May 05, 2000 12:39 PM >> To: Pete Ruehle; 'SmartCam Forum' >> Subject: Re: [mfg-smartcam] icon button madness >> >> i usually spray a shot or two of WD-40 on the screen when this happens to >> me and it works everytime! >> be sure to use the straw so you can direct the stream toward the edge of >> the buttons in question. >> >> >> >> At 12:08 PM 5/5/2000 -0400, Pete Ruehle wrote: >> >Ok, I know many of you will probably think I've misplaced a few cards >> from >> >my deck, but I find this very amusing: >> > >> >Very often, when I click on a an icon button, it "depresses" or pushes in >> >but fails to pop back out. It gets stuck!!! As if it were a mechanical >> >device that is binding. The command does not start with the button >> "stuck" >> >in the in position. I have to click on it again so it "pops" out. >> > >> >I'm not really looking for a fix or an explanation (although I am >> curious); >> >as I said, I find it pretty funny. >> > >> > >> > >> > >> >_______________________________________________________ >> >Peter Ruehle >> >Semiconductor Packaging Materials >> >[EMAIL PROTECTED] >> >http://www.sempck.com >> >(914) 273-5500 >> > >> >====================================================================== >> >To find out more about this mailing list including how to unsubscribe, >> >send the message "info mfg-smartcam" to [EMAIL PROTECTED] >> >====================================================================== >> > >> > >> Ernie Gemmel >> CNC Supervisor >> Apollo Microwaves Ltd. >> Tel (514)426-5959 >> Fax (514)426-3747 >> ====================================================================== >> To find out more about this mailing list including how to unsubscribe, >> send the message "info mfg-smartcam" to [EMAIL PROTECTED] >> ====================================================================== > > Ernie Gemmel CNC Supervisor Apollo Microwaves Ltd. Tel (514)426-5959 Fax (514)426-3747 ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
