Thanks Ernie!!! I'll give it a try!
> -----Original Message-----
> From: Ernie Gemmel [SMTP:[EMAIL PROTECTED]]
> Sent: Friday, May 05, 2000 12:39 PM
> To: Pete Ruehle; 'SmartCam Forum'
> Subject: Re: [mfg-smartcam] icon button madness
>
> i usually spray a shot or two of WD-40 on the screen when this happens to
> me and it works everytime!
> be sure to use the straw so you can direct the stream toward the edge of
> the buttons in question.
>
>
>
> At 12:08 PM 5/5/2000 -0400, Pete Ruehle wrote:
> >Ok, I know many of you will probably think I've misplaced a few cards
> from
> >my deck, but I find this very amusing:
> >
> >Very often, when I click on a an icon button, it "depresses" or pushes in
> >but fails to pop back out. It gets stuck!!! As if it were a mechanical
> >device that is binding. The command does not start with the button
> "stuck"
> >in the in position. I have to click on it again so it "pops" out.
> >
> >I'm not really looking for a fix or an explanation (although I am
> curious);
> >as I said, I find it pretty funny.
> >
> >
> >
> >
> >_______________________________________________________
> >Peter Ruehle
> >Semiconductor Packaging Materials
> >[EMAIL PROTECTED]
> >http://www.sempck.com
> >(914) 273-5500
> >
> >======================================================================
> >To find out more about this mailing list including how to unsubscribe,
> >send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> >======================================================================
> >
> >
> Ernie Gemmel
> CNC Supervisor
> Apollo Microwaves Ltd.
> Tel (514)426-5959
> Fax (514)426-3747
> ======================================================================
> To find out more about this mailing list including how to unsubscribe,
> send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> ======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
