Ernie: That did it! Not only did it solve the sticky button problem; Smartcam even runs faster now. Files open 50% faster. I'm going to try some of that on the server; maybe I can get the Internet to speed up too.
> -----Original Message----- > From: Ernie Gemmel [SMTP:[EMAIL PROTECTED]] > Sent: Friday, May 05, 2000 1:07 PM > To: Pete Ruehle; Pete Ruehle; 'SmartCam Forum' > Subject: RE: [mfg-smartcam] icon button madness > > No prob pete! > oh, one other thing, if the button doesn't pop out right away, be sure to > leave the room before the monitor blows to bits. > > > At 12:51 PM 5/5/2000 -0400, Pete Ruehle wrote: > >Thanks Ernie!!! I'll give it a try! > > > >> -----Original Message----- > >> From: Ernie Gemmel [SMTP:[EMAIL PROTECTED]] > >> Sent: Friday, May 05, 2000 12:39 PM > >> To: Pete Ruehle; 'SmartCam Forum' > >> Subject: Re: [mfg-smartcam] icon button madness > >> > >> i usually spray a shot or two of WD-40 on the screen when this happens > to > >> me and it works everytime! > >> be sure to use the straw so you can direct the stream toward the edge > of > >> the buttons in question. > >> > >> > >> > >> At 12:08 PM 5/5/2000 -0400, Pete Ruehle wrote: > >> >Ok, I know many of you will probably think I've misplaced a few cards > >> from > >> >my deck, but I find this very amusing: > >> > > >> >Very often, when I click on a an icon button, it "depresses" or pushes > in > >> >but fails to pop back out. It gets stuck!!! As if it were a > mechanical > >> >device that is binding. The command does not start with the button > >> "stuck" > >> >in the in position. I have to click on it again so it "pops" out. > >> > > >> >I'm not really looking for a fix or an explanation (although I am > >> curious); > >> >as I said, I find it pretty funny. > >> > > >> > > >> > > >> > > >> >_______________________________________________________ > >> >Peter Ruehle > >> >Semiconductor Packaging Materials > >> >[EMAIL PROTECTED] > >> >http://www.sempck.com > >> >(914) 273-5500 > >> > > >> >====================================================================== > >> >To find out more about this mailing list including how to unsubscribe, > >> >send the message "info mfg-smartcam" to [EMAIL PROTECTED] > >> >====================================================================== > >> > > >> > > >> Ernie Gemmel > >> CNC Supervisor > >> Apollo Microwaves Ltd. > >> Tel (514)426-5959 > >> Fax (514)426-3747 > >> ====================================================================== > >> To find out more about this mailing list including how to unsubscribe, > >> send the message "info mfg-smartcam" to [EMAIL PROTECTED] > >> ====================================================================== > > > > > Ernie Gemmel > CNC Supervisor > Apollo Microwaves Ltd. > Tel (514)426-5959 > Fax (514)426-3747 > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
