Hi everyone,
I recently had to program (manually) a part that required rotary
milling, I was wondering if anyone has any ideas on getting Smartcam to
output something similar.
Here is a snippet of the required code:
N1 G0 X6.0 Y.25 A-10.0
N2 G1 X7.0
N3 G1 Y-.25 A10.0
N4 G1 X6.0
NOTES: The rotary table is actually tilted @ 30'
line 3 has the tool and the table moving in the same
direction ( the side walls point to the center of rotation, and the tool
needs to be offset (1) cutter radius)
Thanks,
J.G.
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
