I recall having the same problem when I exceeded the number of allowable elements in a file. Nothing happened until I exited SmartCam, then tried to reload the file. No go!
However, I was able to edit the Smartcam.ini file to increase the number of allowable elements, and then I could reopen the file. Since Paul's buddy was merging files at the time of the problem, this could be the reason. It's worth a try. I normally set the number of elements at 200000. Gene Bowen Jeff Brower wrote: > I'm unsure if this is related but we had the same problem with some files > some time ago, so it MAY not be OS related but a Version problem. We were > able to open the files in Version 10, save the file, then open the file back > up in Version 11 again! If you have that version CD around still you might > try it out. We had installed version 10 in another folder so we could access > them as needed. I don't have that setup anymore or I could open the file and > save it for you! > > Good luck, > Jeff > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Paul G Anderson > Sent: Tuesday, June 18, 2002 2:53 PM > To: Mfg-Smartcam (E-mail) > Subject: [mfg-smartcam] Anyone using Smartcam on Unix platform ? Help !! > > Hello Group, > Sometime ago I had a corrupt .pm4 that could not be opened > in Version 11 for the pc until it was read into Smartcam for Unix and then > resaved . Does anyone recall doing this for me ? I have this problem again. > My fellow programmer that's sits next to me here was doing something with > Iges and Merging one model into another and corrupted the .pm4. Any help > would be greatly appreciated. Thanks in advance ! > > Paul G Anderson > ME/Programming > Tura Machine Co > 610-534-1800 Ext. 210 > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
