I think there was something to do with element names and there is a patch for it for version 11.0 that brings you to 11.01.
thanks bill ----- Original Message ----- From: genebo <[EMAIL PROTECTED]> To: Jeff Brower <[EMAIL PROTECTED]> Cc: SmartCam <[EMAIL PROTECTED]> Sent: Wednesday, June 19, 2002 9:03 PM Subject: Re: [mfg-smartcam] Anyone using Smartcam on Unix platform ? Help !! > I recall having the same problem when I exceeded the number of allowable > elements in a file. Nothing happened until I exited SmartCam, then tried to > reload the file. No go! > > However, I was able to edit the Smartcam.ini file to increase the number of > allowable elements, and then I could reopen the file. > > Since Paul's buddy was merging files at the time of the problem, this could be > the reason. It's worth a try. > > I normally set the number of elements at 200000. > > Gene Bowen > > Jeff Brower wrote: > > > I'm unsure if this is related but we had the same problem with some files > > some time ago, so it MAY not be OS related but a Version problem. We were > > able to open the files in Version 10, save the file, then open the file back > > up in Version 11 again! If you have that version CD around still you might > > try it out. We had installed version 10 in another folder so we could access > > them as needed. I don't have that setup anymore or I could open the file and > > save it for you! > > > > Good luck, > > Jeff > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED]]On Behalf Of Paul G Anderson > > Sent: Tuesday, June 18, 2002 2:53 PM > > To: Mfg-Smartcam (E-mail) > > Subject: [mfg-smartcam] Anyone using Smartcam on Unix platform ? Help !! > > > > Hello Group, > > Sometime ago I had a corrupt .pm4 that could not be opened > > in Version 11 for the pc until it was read into Smartcam for Unix and then > > resaved . Does anyone recall doing this for me ? I have this problem again. > > My fellow programmer that's sits next to me here was doing something with > > Iges and Merging one model into another and corrupted the .pm4. Any help > > would be greatly appreciated. Thanks in advance ! > > > > Paul G Anderson > > ME/Programming > > Tura Machine Co > > 610-534-1800 Ext. 210 > > > > ====================================================================== > > To find out more about this mailing list including how to unsubscribe, > > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > > ====================================================================== > > > > ====================================================================== > > To find out more about this mailing list including how to unsubscribe, > > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > > ====================================================================== > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
