I made a homemade tool out of desperation that worked great. I took a scrap
piece of wood that was about .75 X .75 X 12 inches. I put 2 decking screws into
one end to correspond with the slots on the mast cover...approximately 1 inch
apart. The tips of the screws jutted out one side about .25 inch. The tips of
these screws were spaced to match the slots on the antenna mast cover. This
tool easily removed the cover when I couldn't get it off any other way short of
destroying it. I spent about 10 minutes building the tool and removing the
threaded cover...no damage.
regards...Steve
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
