One way to check the hydraulics is to measure the throw at the end of
the release arm. IIRC, should be about 12-13mm.
 

Bill Cardell 
TurboDog's Dad 
www.flyinmiata.com 
www.fmwestfield.com 
Sales 1-800-359-6957 
Tech 970-464-5600 Before you call, check out
http://www.flyinmiata.com/FAQ/ 

 

________________________________

From: Luis [mailto:[email protected]] 
Sent: Wednesday, March 24, 2010 6:32 PM
To: 'Ray'; Bill Cardell; [email protected]
Subject: RE: Clutch not fully releasing...ACT 1.8 Happy Meal setup...



Wait! Hold the phone! Don't pull the tranny yet!

 

Couldn't this be a simple clutch master cylinder failure?

 

 

 

Luis

 

________________________________

From: [email protected]
[mailto:[email protected]] On Behalf Of atomicarlton
Sent: Wednesday, March 24, 2010 7:51 PM
To: Ray; atomicarlton; Bill Cardell; [email protected]
Subject: RE: Clutch not fully releasing...ACT 1.8 Happy Meal setup...

 

Ray,

I just reused the pilot bearing that was in there when I did the tranny
swap last year. If you recall, I was in a hurry to give my wife a reason
to drop me on my ass......

I am preparing myself for another tranny pull.

Eric

________________________________

From: Ray <[email protected]>
Sent: Wednesday, March 24, 2010 7:34 PM
To: atomicarlton <[email protected]>; Bill Cardell
<[email protected]>; [email protected]
Subject: Re: Clutch not fully releasing...ACT 1.8 Happy Meal setup...

Did you remember to replace the pilot bearing last year?

        ----- Original Message -----

        From: atomicarlton <mailto:[email protected]> 

        To: Bill Cardell <mailto:[email protected]>  ; atomicarlton
<mailto:[email protected]>  ; [email protected]

        Sent: Wednesday, March 24, 2010 11:27 AM

        Subject: RE: Clutch not fully releasing...ACT 1.8 Happy Meal
setup...

         

        I will try redoing the adjustments.....I was hoping too not drop
the trans AGAIN....had all my fun doing that last year. :-)
        
        Eric

        
________________________________


        From: Bill Cardell <[email protected]>



[The entire original message is not included]

_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to