I'd be looking at the tranny/TQ/flexplate area.
Larry Alster 91 Miata White Knight 92 Miata Silver Bullet 92 Miata Honey B 04 MSM MX-5 Whooosh 06 WRX STi Subie From: [email protected] [mailto:[email protected]] On Behalf Of Chad J. Douglas Sent: Tuesday, July 13, 2010 9:16 PM To: [email protected] Subject: My Turn: Engine Seized? OK, so I put the new motor into this NC. The motor turned over just fine by hand while I was bolting the torque converter to the flexplate. Then, we installed the engine, and I proceeded to hook everything up. So, tonight, I had it together enough to try to start it (or at least verify that the engine turned, etc), and all I get from the starter is a very definate LOUD CLICK. So I tried jumping it and charging it - no dice. Somehow, the engine is physically locked. I cannot turn the engine from the crank bolt or by gently prying on the flexplate teeth to turn the engine from the back side. Tried with tranny in Park and Neutral, with and without driveshaft, Any ideas? I'm stumped - I have no idea why this NC motor would turn over by hand just a few days ago, and now refuses. It won't turn either direction, although I didn't really try that hard to turn it backwards, since I've read horror stories about bending valves on this engine if you turn it backwards... But I would have expected it to turn a teeny bit backward, but nothing. It's like the motor is welded. Tomorrow, I'm going to remove the valve cover to be sure that some tool didn't get in there when I swapped the VC (god, I hope not!) but it's the only area of the engine that was exposed that could possible lead to a physical lockup. Aside from that... Any notions?
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
