Cleared should be 0.0.0.0 for the IP if it has the 192.168.88.1 ( not 0 ) address it's got a config that may have conflicts...
On 11/09/2012 12:08 PM, Jerry Roy wrote: > I attempted to use flashfig to test if the .rsc file I created would be > imported. It does but with issues. Only problem is it still does not get > entire config. I export a file called fullconfig.rsc that has all my > settings and then I reset router back to what it came with from "factory" > (Lan 192.168.88.0/24, Nat and dhcp client on Wan). I run netinstall, > flashfig and select my file. Pull the power and plug ethernet cable into > port 1. Plug in power and it says "flashfigged". I go and look at the > settings and NTP is missing, snmp is missing. I am not sure all of the > settings that are not re-applied. > > Is the order of the commands what is causing portions to not be imported? > Does anyone have a document that explains what the best order the commands > should be in? > > Any other Ideas? > > *Jerry Roy* > -------------- next part -------------- > An HTML attachment was scrubbed... > URL: > <http://www.butchevans.com/pipermail/mikrotik/attachments/20121109/2108755d/attachment.html> > _______________________________________________ > Mikrotik mailing list > Mikrotik@mail.butchevans.com > http://www.butchevans.com/mailman/listinfo/mikrotik > > Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS > _______________________________________________ Mikrotik mailing list Mikrotik@mail.butchevans.com http://www.butchevans.com/mailman/listinfo/mikrotik Visit http://blog.butchevans.com/ for tutorials related to Mikrotik RouterOS
