On Friday 29 November 2013 17:12:45 Erling Westenvik wrote: > On Fri, Nov 29, 2013 at 01:10:24PM +0100, Aurelien Martin wrote: > > stty com0 57600 > > I too would try with a lower baudrate. > > >From the FAQ (http://www.openbsd.org/faq/faq7.html#SerCon) > > "Resist the urge to crank the baud rate up to the maximum your > hardware can support, as you are more likely to create problems > than benefit. Most systems have a "default" speed (supported by > default by the boot ROM and/or the boot loader, often 9600), use > this unless you have real reason to use something different."
Huh? My ALIX 2D13 works fine with 115200 - no quirks. 38400 is default but I don't think that a wrong baudrate would output anything at all except house numbers and grzmrf, especially not at high baudrates. Did you, Aurelien use a quality CF-card? That is very important. Is the power supply sound? Even the 2D3 may be defective (rarely) and e.g. PC-Engines swaps them on warranty free. Sorry I didn't upgrade to 5.4 yet. I installed OpenBSD 5.3 onto the CF-card while it was connected to a MACbook Air via a USB-adaptor and used the network install. Then I inserted the CF-card into the ALIX 2D13 and booted. No problems. See OBSD FAQ 14.17.3. Maybe Aurelien, you want to try this before you send the board back to the supplier. Good luck Eike -- Eike Lantzsch ZP6CGE Casilla de Correo 1519 1209 Asuncion / Paraguay
