On Tue, Sep 28, 2021 at 10:04:25AM -0700, Joseph Olatt wrote: > I tried the following snapshot: > > https://cdn.openbsd.org/pub/OpenBSD/snapshots/arm64/miniroot70.img > > Build date: 27-Sep-2021 20:10 > Size: 45088768 > > Didn't have much luck. The install process rebooted after the following > error: > > bwfm0: failed loadfirmware of file > brcmfmac43455-sdio.raspberrypi,4-model-b.bin > panic: do_el0_error
What happens when you boot with -c and 'disable bwfm' then exit? Is that not an option anymore? Best Regards, -peter PS: look lower at boot line below > Wonder if the following error in the beginning (full transcript of > install process listed below): > > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > > has anything to do with my woes... > > Next, I'll try the pftf UEFI firmware mentioned in INSTALL.arm64, per > your suggestion, as soon as I find some spare time. > > > /* Full transcript of install */ > Connected to /dev/cuaU0 (speed 115200) > > > U-Boot 2021.07 (Aug 12 2021 - 02:45:29 -0600) > > DRAM: 3.9 GiB > RPI 4 Model B (0xc03114) > MMC: mmcnr@7e300000: 1, emmc2@7e340000: 0 > Loading Environment from FAT... Unable to read "uboot.env" from mmc0:1... > In: serial > Out: serial > Err: serial > Net: eth0: ethernet@7d580000 > PCIe BRCM: link up, 5.0 Gbps x1 (SSC) > starting USB... > Bus xhci_pci: Register 5000420 NbrPorts 5 > Starting the controller > USB XHCI 1.00 > scanning bus xhci_pci for devices... 2 USB Device(s) found > scanning usb for storage devices... 0 Storage Device(s) found > Hit any key to stop autoboot: 0 > switch to partitions #0, OK > mmc0 is current device > Scanning mmc 0:1... > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > Card did not respond to voltage select! : -110 > Scanning disk mm...@7e300000.blk... > Disk mm...@7e300000.blk not ready > Scanning disk em...@7e340000.blk... > ** Unrecognized filesystem type ** > Found 3 disks > No EFI system partition > BootOrder not defined > EFI boot manager: Cannot load any image > Found EFI removable media binary efi/boot/bootaa64.efi > 170694 bytes read in 33 ms (4.9 MiB/s) > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > Booting /efi\boot\bootaa64.efi > disks: sd0* > >> OpenBSD/arm64 BOOTAA64 1.6 > boot> ^^^^^---- right here type -c or 'boot -c' > cannot open sd0a:/etc/random.seed: No such file or directory > booting sd0a:/bsd: 2574016+699492+13009456+629216 > [216000+109+596472+233168]=0x14014c8 > type 0x0 pa 0x0 va 0x0 pages 0x1 attr 0x8 > type 0x7 pa 0x1000 va 0x1000 pages 0x1ff attr 0x8 > type 0x2 pa 0x200000 va 0x200000 pages 0x4000 attr 0x8 > type 0x7 pa 0x4200000 va 0x4200000 pages 0x3cf0 attr 0x8 > type 0x9 pa 0x7ef0000 va 0x7ef0000 pages 0x20 attr 0x8 > type 0x7 pa 0x7f10000 va 0x7f10000 pages 0x31ef0 attr 0x8 > type 0x4 pa 0x39e00000 va 0x39e00000 pages 0x1 attr 0x8 > type 0x7 pa 0x39e01000 va 0x39e01000 pages 0x1 attr 0x8 > type 0x2 pa 0x39e02000 va 0x39e02000 pages 0x100 attr 0x8 > type 0x1 pa 0x39f02000 va 0x39f02000 pages 0x2a attr 0x8 > type 0x0 pa 0x39f2c000 va 0x39f2c000 pages 0x7 attr 0x8 > type 0x4 pa 0x39f33000 va 0x39f33000 pages 0x1 attr 0x8 > type 0x6 pa 0x39f34000 va 0x3d35274000 pages 0x1 attr 0x8000000000000008 > type 0x4 pa 0x39f35000 va 0x39f35000 pages 0x2 attr 0x8 > type 0x0 pa 0x39f37000 va 0x39f37000 pages 0x1 attr 0x8 > type 0x6 pa 0x39f38000 va 0x3d35278000 pages 0x3 attr 0x8000000000000008 > type 0x4 pa 0x39f3b000 va 0x39f3b000 pages 0x1 attr 0x8 > type 0x6 pa 0x39f3c000 va 0x3d3527c000 pages 0x4 attr 0x8000000000000008 > type 0x0 pa 0x39f40000 va 0x39f40000 pages 0x1 attr 0x8 > type 0x4 pa 0x39f41000 va 0x39f41000 pages 0x1 attr 0x8 > type 0x0 pa 0x39f42000 va 0x39f42000 pages 0x1 attr 0x8 > type 0x4 pa 0x39f43000 va 0x39f43000 pages 0x2 attr 0x8 > type 0x0 pa 0x39f45000 va 0x39f45000 pages 0x1 attr 0x8 > type 0x4 pa 0x39f46000 va 0x39f46000 pages 0x2 attr 0x8 > type 0x2 pa 0x39f48000 va 0x39f48000 pages 0x1408 attr 0x8 > type 0x5 pa 0x3b350000 va 0x3d36690000 pages 0x10 attr 0x8000000000000008 > type 0x2 pa 0x3b360000 va 0x3b360000 pages 0xa0 attr 0x8 > type 0x0 pa 0x3ef5c000 va 0x3ef5c000 pages 0x1 attr 0x8 > type 0x4 pa 0x40000000 va 0x40000000 pages 0xbc000 attr 0x8 > type 0xb pa 0xfe100000 va 0x3d366a0000 pages 0x1 attr 0x8000000000000000 > Copyright (c) 1982, 1986, 1989, 1991, 1993 > The Regents of the University of California. All rights reserved. > Copyright (c) 1995-2021 OpenBSD. All rights reserved. > https://www.OpenBSD.org > > OpenBSD 7.0 (RAMDISK) #1249: Mon Sep 27 20:10:08 MDT 2021 > dera...@arm64.openbsd.org:/usr/src/sys/arch/arm64/compile/RAMDISK > real mem = 4124962816 (3933MB) > avail mem = 3961278464 (3777MB) > random: good seed from bootblocks > mainbus0 at root: Raspberry Pi 4 Model B Rev 1.4 > cpu0 at mainbus0 mpidr 0: ARM Cortex-A72 r0p3 > cpu0: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache > cpu0: 1024KB 64b/line 16-way L2 cache > cpu0: CRC32,ASID16 > efi0 at mainbus0: UEFI 2.8 > efi0: Das U-Boot rev 0x20210700 > "system" at mainbus0 not configured > "axi" at mainbus0 not configured > simplebus0 at mainbus0: "soc" > bcmclock0 at simplebus0 > bcmmbox0 at simplebus0 > bcmgpio0 at simplebus0 > bcmaux0 at simplebus0 > ampintc0 at simplebus0 nirq 256, ncpu 4: "interrupt-controller" > syscon0 at simplebus0: "avs-monitor" > "thermal" at syscon0 not configured > bcmdmac0 at simplebus0: DMA0 DMA2 DMA4 DMA5 DMA6 DMA7 DMA8 DMA9 > "timer" at simplebus0 not configured > pluart0 at simplebus0: console > "local_intc" at simplebus0 not configured > bcmdog0 at simplebus0 > bcmirng0 at simplebus0 > "firmware" at simplebus0 not configured > "power" at simplebus0 not configured > "mailbox" at simplebus0 not configured > sdhc0 at simplebus0 > sdhc0: SDHC 3.0, 250 MHz base clock > sdmmc0 at sdhc0: 4-bit, sd high-speed, mmc high-speed > "gpiomem" at simplebus0 not configured > "fb" at simplebus0 not configured > "vcsm" at simplebus0 not configured > "clocks" at mainbus0 not configured > "phy" at mainbus0 not configured > "clk-27M" at mainbus0 not configured > "clk-108M" at mainbus0 not configured > simplebus1 at mainbus0: "emmc2bus" > sdhc1 at simplebus1 > sdhc1: SDHC 3.0, 100 MHz base clock > sdmmc1 at sdhc1: 8-bit, sd high-speed, mmc high-speed, ddr52, dma > "arm-pmu" at mainbus0 not configured > agtimer0 at mainbus0: 54000 kHz > simplebus2 at mainbus0: "scb" > bcmpcie0 at simplebus2 > pci0 at bcmpcie0 > bse0 at simplebus2: address e4:5f:01:40:4d:18 > brgphy0 at bse0 phy 1: BCM54210E 10/100/1000baseT PHY, rev. 2 > "dma" at simplebus2 not configured > "hevc-decoder" at simplebus2 not configured > "rpivid-local-intc" at simplebus2 not configured > "h264-decoder" at simplebus2 not configured > "vp9-decoder" at simplebus2 not configured > "leds" at mainbus0 not configured > "sd_io_1v8_reg" at mainbus0 not configured > "sd_vcc_reg" at mainbus0 not configured > "fixedregulator_3v3" at mainbus0 not configured > "fixedregulator_5v0" at mainbus0 not configured > simplebus3 at mainbus0: "v3dbus" > "bootloader" at mainbus0 not configured > scsibus0 at sdmmc1: 2 targets, initiator 0 > sd0 at scsibus0 targ 1 lun 0: <SD/MMC, EB1QT, 0030> removable > sd0: 30528MB, 512 bytes/sector, 62521344 sectors > bwfm0 at sdmmc0 function 1 > manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 2 not configured > manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 3 not configured > softraid0 at root > scsibus1 at softraid0: 256 targets > root on rd0a swap on rd0b dump on rd0b > WARNING: CHECK AND RESET THE DATE! > gpio at bcmgpio0 not configured > bwfm0: failed loadfirmware of file > brcmfmac43455-sdio.raspberrypi,4-model-b.bin > panic: do_el0_error > syncing disks... done > > dump to dev 17,1 not possible > rebooting... >
