Hello, I think I have very basic question. I am using mitk 2018 to navigate, using Aurora NDI Tracking System. I have two tools (two different sensors), which are auto detected through MITK. I calibrate first one by Pivoting Calibration, then I calibrate the second one by Single Reference Tool and everything runs perfectly. However when I want to save all this data to be able to connect it later and not repeat all calibration steps I don't find the way: - When I performed tool tip calibration with a single reference tool, I find at the bottom the option to *"Save calibrated Navigation Tool", *and I save it as .IGTTool. This format is useful only to load tools into a new Toolstorage? - If I create a new Toolstorage, and I try to load it into the Tracking Toolbox, Tools section, when I try to connect the tracker it gives me the following error: [image: image.png] Even if I have copied the serial number of the NDI tool in each saved tool.
What is the correct way to proceed with this? I am sure I am missing something! It is possible to save calibrated tools and re-use them in a new mitk session right? Any help will be welcome! Thank you very much in advance! Best regards and have a nice weekend, Rocio -- Rocío López Velazco *SimbioSYS** group, BCN MedTech* *UniversityPompeu Fabra* *Department of Information and Communication Technologies Roc Boronat, 122 (Tànger Building), 08018 Barcelona Office 55 119 https://bcn-medtech.upf.edu/ <https://bcn-medtech.upf.edu/>*
_______________________________________________ mitk-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/mitk-users
