Hi All For those of you who remember I'm the guy trying to install a Montgomery 15 centerboard (hull #256) that had been removed from the boat and completely glassed over (closing the pivot pin hole).
Well - today I jacked up the boat, drove out the 1/2" ss pin (good condition) from the centerboard trunk and proceeded to try to fit the c.b. in the trunk. Q: When the c.b. is correctly installed - I am assuming that it fully retracts inside the cb trunk so that none of the boats weight reasts on the c.b when on the trailer. Is this correct? If so, then I have a problem because when I install the c.b so that it is fully in the trunk the pivot pin passes just in front of the board. (barely touches the board) I am assuming that when the c.b. was repaired/glassed over, a part of the board near the pivot pin hole had been damaged/removed and was not replaced! If all the above assumptions are correct - I am going to have to add on to the top of the c.b. I am capable of doing the glassing but would need a pattern. Does anybody have their c.b. out of the boat that would be willing to send me a tracing ?? In return I offer free dockage (transient)on East Bay (part of St. Andrews Bay) including water and power! (About 15 miles east of Panama City, Florida on ICW) (Actually this offer is good to anyone - just email me at [EMAIL PROTECTED] to arrange.) Thanks in advance Bud __________________________________________________ Do you Yahoo!? Yahoo! Mail Plus - Powerful. Affordable. Sign up now. http://mailplus.yahoo.com _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
