Was that a typo for the APPLICID ? Ours have: Application ID : CSQX START. The command Ref manulal says that's what it should be for distributed queueing without CICS.
Richard. Mark Steely <[EMAIL PROTECTED]>@AKH-WIEN.AC.AT> on 26/11/2002 09:25:39 Please respond to MQSeries List <[EMAIL PROTECTED]> Sent by: MQSeries List <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] cc: Subject: Channel Initiation on OS/390. Channel Initiation on OS/390. We are OS/390 V2.8 amd MQ Series V2.1. MQ on OS/390 has been configured with the appropriate Queue and Channel definitions. However, channels communicating with distributed MQ Qmgrs refuse to initiate. The XmitQ definition is set with a Process that is defined with APPLTYPE(MVS) and APPLICID(QX52 START). The initiation queue name being used in the XMITQ definition is: INITQ(SYSTEM.CHANNEL.INITQ). The channels will not initiate. What definitions are missing to make a distributed TCP channel initiate properly? -Jon --------------------------------------------------------------------- The contents of this e-mail are confidential. If you have received this communication by mistake, please advise the sender immediately and delete the message and any attachments. The views expressed in this e-mail are not necessarily the views of Westpac Banking Corporation. Westpac Banking Corporation is incorporated in New South Wales, Australia. --------------------------------------------------------------------- Instructions for managing your mailing list subscription are provided in the Listserv General Users Guide available at http://www.lsoft.com Archive: http://vm.akh-wien.ac.at/MQSeries.archive