Sneaky hack: Slap an in+out rate limit on the vlan with high settings
(i.e. same as port/lag speed) and just graph the OID of the rate limit
counter :-)
Might need to take a multiplier calculation/CDEF into account based on
the number of ports you have in the lag.
The new 8x10 cards have built in ve counters indeed which makes it a lot
easier
On 1/14/13 5:37 PM, Erik Muller wrote:
On 1/14/13 9:00 , James Wininger wrote:
All,
We are running into an issue with Brocade where we are finding it
difficult to to graph VLAN interfaces for bits (in/out) across a
tagged (trunk) interface. On Cisco this is not an issue. So what we
end up with in Cacti is a blank (no data) graph.
Depending on the specific hardware you're using, you may be out of
luck - early generations of MLX/XMR line cards don't support per-vlan
statistics; you need to have the new 8x10GE cards (or a few others of
the current generation) to have those counters available.
-e
--
Jeroen Wunnink
Network Engineer
Atrato IP Networks
jeroen.wunn...@atrato-ip.com
Phone: +31 20 82 00 623