<https://lh6.googleusercontent.com/-Mzng1gdgZFY/TtiahsAn3LI/AAAAAAAAAF0/f69AZEOVR0c/s1600/6-Digit_Display_Driver_%252528AS-2518-21%252529.jpg>
I agree with Nick, a picture would help. Does your display have colon 
separators? 6 digit pinball displays have neither colons nor commas.

On the pinball displays there are a bunch of pins in the middle that are 
not used or redundant or doubled up with other pins. Sometimes these pins 
are cut short or simply not there. Pin 1 is the HV on these displays. There 
will be six digit driver pins which need multiplexing and seven segment 
pins.

Segments are on pins 2,4,6,34,36,40,38
Digits selects are on pins 9,8,7,6,5,4 with 9 being 100,000s and 4 being 
units.

In addition there is a keep alive anode pin on pin 35 tied to HV and 
cathode on pin 32 fed via a resistor (240k).  You can usually see where 
this keep alive dot is, it will be along the bottom somewhere, normally 
just outside the visible display area, behind a mask on the front glass.

Also there is an SKA pin tied low via a 39k resistor on pin 12. Not sure 
what this is for but the -KA suggests another keep alive.

I would have thought, if you don't have any colons to worry about, you 
could hack a pinball display to work if it is of similar dimensions and 
fits your case.

John S


-- 
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To view this discussion on the web, visit 
https://groups.google.com/d/msg/neonixie-l/-/dI4zwoe0hXoJ.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

Reply via email to