On 5/21/12 11:07 AM, heavyleaded wrote:
Hello Everyone,
Wondering if anyone could tell me the best way to remove the red coating
on the tubes?
I purchased some Tesla ZM1082T's with back printing. I want to make sure
to get the red coating off without destroying the back printing.
These tubes were hard to track down and I don't want to ruin them. After
all I think it would be cool to have my clock say Tesla on the back. :)
Thanks
--
You received this message because you are subscribed to the Google
Groups "neonixie-l" group.
To view this discussion on the web, visit
https://groups.google.com/d/msg/neonixie-l/-/vLjOmgXdkoQJ.
To post to this group, send an email to neonixie-l@googlegroups.com.
To unsubscribe from this group, send email to
neonixie-l+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/neonixie-l?hl=en-GB.
The Philips tubes I have had the printing done *over* the red coating,
so you may not be able to achieve your goal.
The red coating comes off by soaking in hot water.
--
David Forbes, Tucson AZ
--
You received this message because you are subscribed to the Google Groups
"neonixie-l" group.
To post to this group, send an email to neonixie-l@googlegroups.com.
To unsubscribe from this group, send email to
neonixie-l+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/neonixie-l?hl=en-GB.
