The hole for the tube is 3.25". I could make a 5" version if there are
enough tubes out there.
I plan to or adapt a little GPS board to be bolted to the top.
On 1/15/16 2:56 PM, 'Terry S' via neonixie-l wrote:
David, how big is that center opening?
Terry
On Thursday, January 14, 2016 at 11:58:11 PM UTC-6, nixiebunny wrote:
I have been doing a lot of component placement work on the new scope
clock board. Tetris! This is what it looks like. The six square controls
with equilateral triangle dots are the oscilloscope knobs, and the
function encoder is at bottom center. The other square pots are trimmers
accessible through the front panel.
The HV power supply is at upper left, deflection at upper right, V power
lower left, computer at lower right. A big USB-B connector is behind the
lower right corner. RTC battery is at bottom.
The thru-hole parts (other than controls) are rear mounted, with all SMT
parts on the front. There will be 5/16" standoffs in the six outer holes
to mount the board to the front panel.
This is a work in progress.
--
David Forbes, Tucson AZ
--
David Forbes, Tucson AZ
--
You received this message because you are subscribed to the Google Groups
"neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to neonixie-l+unsubscr...@googlegroups.com.
To post to this group, send an email to neonixie-l@googlegroups.com.
To view this discussion on the web, visit
https://groups.google.com/d/msgid/neonixie-l/56997A39.7060700%40dakotacom.net.
For more options, visit https://groups.google.com/d/optout.