Here is the documentation for my Zev clock. Mitch
On Tuesday, November 15, 2016 at 3:53:14 AM UTC-5, SWISSNIXIE - Jonathan F. wrote: > > Hi > > I know a lot of people here have assembled kits or build there own clock. > For driving nixies there are not too many different ways. Since im more > "builder" than "programmer" i want to make a firmware thats really good, > and use the same firmware for all my future clock projects, so i don't need > to make a new code for each project and only need to change pin definitions > or values! Of course, i want to share that firmware along with my > schematic! Link to my current board! > <http://swissnixie.com/index.php?go=sunixs> > > I just wanna ask what people would like to have in a firmware option! > > Imagine you have a nixie clock with 6 Tubes (each has 10 digits) and 2 > colon separators (each can be driven alone). For the settings there is a > rotary encoder. The Anodes are fixed (no anode pwm). > > > > > > *What options would should there be?*List of current features: > > > - Different Cycle (Anti-Poisioning-Routinge) choices (each minute, > each 10minute, each hr, off) > - Cycle speed (1-99%) 1%= cycling around 5 seconds (very long!) > - Numbers of cycle (1-10) > - AM/PM Mode ( 24hr, 12hr, 12hr with indication with the separators) > - colon separator options (left on, right on, both on, both of, blink > each second, overwrite AM/PM indication) > - time-setting via Serial > - LED brightness > - LED colors (16 different) > - Automatic Daylight Saving change* (on off) (and menu to set > start/end date) > This works by setting the time over serial, the date when the time was > set, will be saved into eeprom. On reset, it will check if the date was in > daylight saving time or not, and checks if today's date is in daylight > saving time or not, and then will react by change the time by +1 or -1. > - GPS sync (on/off) (if receiver connected). > - Manual time setting (hh:mm, s = 00 when pressing save) > - Date display by a single button push. > > > > Any ideas? :) > > > Thanks > > - Jonathan > > > > > -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to neonixie-l+unsubscr...@googlegroups.com. To post to this group, send an email to neonixie-l@googlegroups.com. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/6cb57297-2f33-49ff-ae11-b2ba56aa967c%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
ZevManualV2.doc
Description: MS-Word document
