Hi Jim,
Thanks!
Andrew
On Mar 19, 2011, at 3:53 PM, Jim wrote:
Hi Andrew,
I'll forward this on.............another kind member (sorry, not
sure who) had posted it previously. Hope it helps. Good luck!
Regards, Jim
At 03:06 PM 3/19/2011, you wrote:
Dear Neotek list,
I have been trying to source schematics for the pair of
Neotek 1E
channel strips I recently acquired... Found a thread, here, which
read to go
to DIY. Went to DIY but, so far, only found a thread which read
to go to
Neotek list. (: Full Moebius.
Anyway, I'm having trouble getting my Phantom power going, after
remnove and replace of the strips (from a rack chassis to a
console). Had
to desolder the leds (the Phantom's of which, now, don't light
up), and,
also, when I removed the Molex connectors for the balancing
boards, a couple
of wires got loose. I think I snuggled them back into the right
holes and
got the power light on and all functions, except phantom power on
both
channel strips in question and the line input on one of them.
Any ideas welcome,
Thanks,
Andrew
------
View the list online at: http://www.mail-archive.com/
[email protected]
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe neotek" in the
message body. If you have any difficulties, or questions --please
send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that
any message or reply sent to the list will be automatically
forwarded to all subscribers.
Vive Le Neotek!
Thanks.<IE INPUT MODULE.1.jpg>
------
View the list online at: http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any message
or reply sent to the list will be automatically forwarded to all subscribers.
Vive Le Neotek!
Thanks.
