Hi,
I executed the sys-unconfig and answered as follwows.
select a language -- 0(English)
select a locale --0 (English)
key board layout --US-English
Networked -- yes
use DHCP for rtls0-- yes
enable IPv6 for rtls0-- no
configure kerberos Security --no
Name Service -- None
NFSv4 Domain Configuration -- use the NFSv4 domain derived by the system
and so on..
it further asked my root password, date time settings etc.
What went wrong in above mentioned steps?
Do I need to contact my ISP to get it's IP address?
further I executed ifconfig and netstat.The results were as follows.
# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
rtls0: flags=1004843<UP,BROADCAST,RUNNING,MULTICAST,DHCP,IPv4> mtu 1500 index 2
inet 192.168.1.100 netmask ffffff00 broadcast 192.168.1.255
ether 0:16:76:84:7b:b0
# netstat -nr
Routing Table: IPv4
Destination Gateway Flags Ref Use Interface
-------------------- -------------------- ----- ----- ---------- ---------
default 192.168.1.254 UG 1 0 rtls0
192.168.1.0 192.168.1.100 U 1 1 rtls0
224.0.0.0 192.168.1.100 U 1 0 rtls0
127.0.0.1 127.0.0.1 UH 12 482 lo0
#
Still Ping doesn't work.
Do I need to configure DNS? Which values should I use over there?
Do I need to make any changes in the configuration?
Thanking You!
Prashant Poman.
This message posted from opensolaris.org
_______________________________________________
networking-discuss mailing list
[email protected]
