Hi, the downloaded driver from broadcom (version 4.0.4) does only support /kernel/drv/bnx.conf:mtu= ... (instead of Jumbo=...) in the configuration file. I was not able to active jumboframes with this driver.
I installed a new opensolars 1/08 with the sun-included bnx driver (Broadcom NXII GbE v3.5.6.1). In this bnx.conf, i have to set the /kernel/drv/bnx.conf:Jumbo=0,9000,... After reboot i tried to set the mtu via "ifconfig bnx1 mtu 9000 up" - but i got "setifmtu: SIOCSLIFMTU: bnx1: Invalid argument" I tried to enable jumbo-frames with ndd, but ndd /dev/bnx1 '?' told me, there's no parameter jumbo to set .... So, i can't enable MTU 9000 with my System HP 460c, onboard Board Broadcom Corporation NetXtreme II BCM5708S Gigabit Ethernet subsystem-vendor-id:0000103c, subsystem-id 0000703b Vendor-id: 14e4 device-id:16ac Question: Does anybody use the bnx driver with mtu 9000 ?? I have no idea for tracking down this problem now ... regards Danny This message posted from opensolaris.org _______________________________________________ networking-discuss mailing list [email protected]
