Daniel Schwager wrote:
> Hi, > > the downloaded driver from broadcom (version 4.0.4) does > only support /kernel/drv/bnx.conf:mtu= ... (instead of Jumbo=...) > in the configuration file. I was not able to active jumboframes > with this driver. > > I installed a new opensolars 1/08 with the sun-included bnx > driver (Broadcom NXII GbE v3.5.6.1). In this bnx.conf, i > have to set the /kernel/drv/bnx.conf:Jumbo=0,9000,... Try it in bnx.conf with: Jumbo = 9000; Then reboot the system. For this setting, the default mtu for the bnx instances will be 9000. Thanks, Samuel > After reboot i tried to set the mtu via "ifconfig bnx1 mtu 9000 up" - but > i got "setifmtu: SIOCSLIFMTU: bnx1: Invalid argument" > > I tried to enable jumbo-frames with ndd, but > ndd /dev/bnx1 '?' > told me, there's no parameter jumbo to set .... > > So, i can't enable MTU 9000 with my > System HP 460c, > onboard Board Broadcom Corporation NetXtreme II BCM5708S Gigabit Ethernet > subsystem-vendor-id:0000103c, subsystem-id 0000703b > Vendor-id: 14e4 device-id:16ac > > Question: Does anybody use the bnx driver with mtu 9000 ?? > > I have no idea for tracking down this problem now ... > > regards > > Danny > > > This message posted from opensolaris.org > _______________________________________________ > networking-discuss mailing list > [email protected] _______________________________________________ networking-discuss mailing list [email protected]
