On Monday 23 August 2004 23:58, mike wrote: > Hoyt Bailey wrote: > > I installed lm_sensors-2.8.5.tar.gz and everything went ok (no > > errors). But when I run sensors-detect the following happens: > > [EMAIL PROTECTED] hoyt]# sensors-detect > > No i2c device files found. Use prog/mkdev/mkdev.sh to create them. > > I dont have a clue about that. > > Now the files are installed:[example,s] > > /usr/src/linux-2.6.3-15mdk/3rdparty/dxr3/em8300_i2c.c > > /usr/src/linux-2.6.3-15mdk/3rdparty/ivtv/ivtv-i2c.c > > and: > > /usr/src/linux-2.6.3-15mdk/drivers/i2c/busses/i2c-parport-light.c > > /usr/src/linux-2.6.3-15mdk/drivers/i2c/busses/i2c-ali1535.c > > There are a lot of them so I would guess that everything is in > > place and probably is in the right place but it isnt being found. > > Any ideas? > > Hoyt, how did you install the package? Take a look at the QUICKSTART > file in the package. Up close to the top it mentions this > > * Verify you are running a 2.4 kernel, 2.4.9 or later. > If you are running a 2.5/2.6 kernel, the ONLY thing you need to > do is 'make user' and 'make user_install'. Do NOT follow the > rest of these instructions. > > I installed by rpm so I can't say if this has anything to do with it > but it might be worth looking at. > > Mike I saw that and did as instructed the installation went well, no errors, the problem is after installation while running sensors-detect. The program cant find i2c and its there in the right place I think. Running 2.6.3.15mdk. I didnt find an rpm for lm_sensors-2.8.5. I had 2.8.4 installed but the temps showed the cpu at 1616F, thought that was a little high. -- Regards; Hoyt Registered Linux User #363264 http://counter.li.org
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________