Eh, no.
This is definiately an HSP Winmodem.
Check out Motorola's site for more info.
-JMS
|-----Original Message-----
|From: Charles A Edwards [mailto:[EMAIL PROTECTED]]
|Sent: Thursday, July 20, 2000 2:57 PM
|To: [EMAIL PROTECTED]
|Subject: Re: [newbie] Motorola Modem
|
|
|
|----- Original Message -----
|From: "Tom Brinkman" <[EMAIL PROTECTED]>
|To: <[EMAIL PROTECTED]>
|Sent: Thursday, July 20, 2000 8:55 AM
|Subject: Re: [newbie] Motorola Modem
|
|
|> On Wed, 19 Jul 2000, you wrote:
|> > Hi guys...
|> > I am trying to make my modem work under linux. I have a Motorola SM56
|> > modem, itīs a PCI one.The specs say it is designed for windows, however
|> > I was told that if it shows as Communication controller on my /proc/pci
|> > I could make it work.
|>
|
|
| You are correct. If it were a winmodem it would be listed as Communication
|devise rather than controller.
| Follow the instructions listed below and you should be able to connect.
|
|
| Log in as root and from terminal enter the following command
| # cat/proc/pci
|This will list all your PCI devices. On this list you should see either
|Communication controller or Communication device, that listing is your
|modem. If it shows as Comm. device you have a winmodem and it won't work in
|Linux. If it shows as Comm. controller proceed as follows:
|Write down the first I/O range. In the example I am using 0xd800 replace
|that with yours.
| Enter the following
| # setserial /dev/ttyS3 port 0xd800 spd_vhi skip_test auto_irq autoconfig
|If there are no errors, then enter
|# setserial /dev/ttyS3 uart 16550A
|
|Select /dev/ttyS3 as the device in kppp and your modem should now initalize
|and operate.
|To make this perm. you will need to edit your rc.local file which
|is located
|in the /etc/rc.d directory. Add the 2 setserial lines to the end of this
|file Save the changes and reboot your system.
|
| Charles
|
|
|
