hey civileme
how are things going on the testing side of the dfe 530-tx
i am still lost and not sure how to get it to run
if you get the solution soon please post it up so i can finally get
connected
thanx
paul
----- Original Message -----
From: "Civileme" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, March 27, 2001 4:09 PM
Subject: Re: [newbie] Sympatico and the D-Link 530-TX problems
> On Tuesday 27 March 2001 05:31, you wrote:
> > Civilme; Where in Quebec? I'm in Montreal.There have been similar
> > complaints from other people in the LUG I belong to. If you're D-Link
> > continues to give you problems, get back to me. I can arrange to have
the
> > card checked, and replaced with something more reliable. We've seen lots
of
> > the D-Link's screw up and there was a bad batch of them around Montreal
for
> > a while. Sympatico was replacing quite a few a couple of months ago. If
the
> > card is good, and still won't work, we can replace it with a DLink
538TX,
> > which will work fine. In the mean time, make sure that your BIOS has
the
> > "Plug 'n' Play O/S" option turned off, and then "Reset Configuration
Data"
> > is enabled. Once you get your PC fired up, log in as root, open a
terminal,
> > and try "ifconfig", and also "ifup eth0" , then send the information
back
> > here.to the forum.
> >
> > Dan LaBine
> > Registered Linux User #190712
>
>
> Ummm Well you start at the capitol building in Montreal, go one block
south,
> turn southwest and continue 5600 kilometers. Wear rubber boots or you
will
> get wet feet.-)
>
> I'm at Mandrakesoft in Paris, and we were testing these D-Link cards,
trying
> to figure why the driver that works with the Rhine chipset doesn't work
with
> that specific card.
>
> Civileme
>
>
