On Friday 19 October 2001 02:51 pm, you wrote: > In Kups the driver is listed in the properties Tab. > > You can see the print parameters if you press the 'Change' button and > select the same driver again. > > Or else you can configure it using SWAT (localhost:631) > There is an Advanced Tab for that printer (KUPS or SWAT will display the > options), the bad news is none of the parameters adjust bottom margin. > > You might like to check out anotherdriver. In KUPS the driver above the > LaserJet 4/4M Plus PS is listed as 'LaserJet 4 Series' However if you use > SWAT you can see the full name is 'LaserJet 4 Series CUPS plus GIMP Print' > I have not tried it since I do not have a LaserJet 4, but everything I have > read about print drivers has said the GIMP drivers are usually superior to > the standard drivers. Certainly for graphics work. Maybe it will handle the > bottom margin differently.
I've managed to change the driver to the one you specified, and lo and behold, the 'Advanced' tab appeared! So I tried to print a test page from KMail. It didn't crop the top! But, it still did crop the bottom, but at least reprinted it on the next page. I'm almost there! Any more suggestions? Strange how I didn't have this problem in LM 8.0... -- Terry Sheltra PC Technician/Network Administrator University of Virginia School of Architecture [EMAIL PROTECTED] 434.982.3047 -------------------------- Registered Linux User #218330
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com