On Thu, 11 Apr 2002 07:09:44 -0600
"Blood Slap" <[EMAIL PROTECTED]> wrote:
> rather than upgrading or reinstalling, could I not just switch to another
> version of XFree86 in the control center and see if that helps?
No it is not that easy.
When you ran the installation the first time and selected 4.20, the 4.20 rpms were the
only ones installed.
You could use mcc to manly change to 3.36 but it is easier and faster to just run an
upgrade install.
Start the installation.
Choose Upgrade, Expert mode.
It will spend a couple of mins looking for pkgs to upgrade.
You need not select any pkgs, just click OK.
You can skip the network and printer configuration.
You will need to let it install the bootloader (before accepting I usually select
modify and remove the entries created as Old since they are just duplicates)
Next configure X selecting your choice, you will be required to insert the appropriate
CD and then you are done.
The whole process will take only 10min.
Charles
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
