This is from another list -- if anyone here can explain, I'll 
cross-post on the CYBERTELECOM-List with full attribution. Thanks.

---------------------> Joe

>X-X-Sender: fm-listproc@localhost
>Date:         Fri, 17 May 2002 22:36:26 -0400
>Reply-To: Telecom Regulation & the Internet 
><[EMAIL PROTECTED]>
>Sender: Telecom Regulation & the Internet 
><[EMAIL PROTECTED]>
>From: fm-listproc <[EMAIL PROTECTED]>
>Subject:      Change to Part 15 ....
>To: [EMAIL PROTECTED]
>Status:  
>
>Any wireless regulatory junkie can turn this into english and paint a
>picture for the future use of 802.11b or other technologies ni 2.4G
>following these changes ... longer range ? higher throughput? Ability to
>use cheaper radios (non-DSSS or FHSS)?
>
>-=Francois=-
>
>
>
>COMMISSION AMENDS PART 15 OF ITS RULES TO FACILITATE
>DEVELOPMENT OF HIGH SPEED WIRELESS SERVICES
>
>         Washington, DC - The FCC has amended its rules to promote the
>introduction of new digital transmission technologies for high-speed
>wireless communications.  Specifically, the Commission has modified Part
>15 of its rules to permit new digital transmission technologies to operate
>in the 902-928 MHz (915 MHz), 2400-2483.5 MHz (2.4 GHz) and 5725-5850 MHz
>(5.7 GHz) bands under the current rules for spread spectrum systems.  The
>Commission also provided flexibility in the design and operation of
>frequency hopping spread spectrum (FHSS) systems in the 2.4 GHz band and
>eliminated the processing gain requirement for direct sequence spread
>spectrum (DSSS) systems.  These actions will foster the development of new
>products and increase consumer choice.
>
>Currently, the Part 15 rules permit the operation of DSSS and FHSS systems
>on a non-licensed basis.  In both techniques, the power density of the
>transmitted signal is reduced, which lowers the possibility that the
>transmitter will cause interference to other devices operating in the
>band.  The Commission has determined that because new digital modulation
>technologies have spectrum characteristics similar to DSSS systems, they
>can operate under the same rules as DSSS devices in the 915 MHz, 2.4 GHz,
>and 5.7 GHz bands without posing additional risk of interference.  Today's
>decision removes the rule that limits systems in these bands to only DSSS
>and FHSS technology.
>
>         Additional actions taken today will permit the use of as few as
>fifteen hopping channels for FHSS in the 2.4 GHz band.  These systems will
>be able to use channel bandwidth up to 5 MHz wide, but they must reduce
>their output power to125 mW if fewer than 75 hopping channels are used.
>This action will allow new FHSS systems to better avoid interference than
>today's systems by enabling them to avoid occupied channels.   The
>Commission also eliminated the processing gain requirement for DSSS
>systems, concluding that manufacturers have market-driven incentives to
>design products that they can withstand interference from other radio
>frequency devices.
>
>The rule changes adopted in this Second Report and Order will provide
>manufacturers flexibility to design and market a more diverse set of
>products which are able to operate efficiently in the unlicensed bands.
>The rule changes will also allow for greater spectrum sharing in the 2.4
>GHz band by removing regulatory barriers to the introduction of new
>non-interfering technologies.
>
>         Action by the Commission May 16, 2002, by Second Report and Order
>(FCC 02-151).   Chairman Powell, Commissioners Abernathy, Copps, and
>Martin, with Commissioner Martin issuing a statement.


-- 

=======================
Joe Plotkin
DSL/Marketing
Bway.net - NYC's Best Internet
=======================
Bway.net
459 Broadway, 2nd floor
New York, NY  10013

vox: 212.982.9800
fax:  212.982.5499
efax: 561.365.5877
email: [EMAIL PROTECTED]
xDSL info: [EMAIL PROTECTED]
web: http://www.bway.net
=======================
--
NYCwireless - http://www.nycwireless.net/
Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/
Archives: http://lists.nycwireless.net/pipermail/nycwireless/

Reply via email to